This latest firmware introduces quite a few features and improvements:
- Full EDID readout to detect DVI devices every time the video output port is cycled.
- Added “Low Res YPbPr” plus scanline filter mode.
- By popular request, added “sleep/off” mode. Press and hold the “Filter” button for 3 seconds to turn the device off. Short tap on the “Filter” button to turn the device back on.
- Auto shut off of video output if no input is detected for 30 seconds. Red LED flashes 3 times to indicate video output power-down. Output is automatically resumed when a valid input is detected again.
- Yet more tweaks to audio output in a futile attempt to maximize compatibility.
With firmware version 1.4, RetroTINK 2X Pro (and 2X Scart) users can finally power-cycle or set their device(s) to sleep mode through a simple button hold/press, without the need to unplug then plug back in the USB cable; a step that will significantly reduce the wear-and-tear on the on-board micro-USB port. Note that each of the subject devices uses its own unique .hex file, so be careful not to mix and match files while updating.
Check out Mike’s release notes, download links and the step-by-step update instructions here: http://bit.ly/39zoAk2
Buy the RetroTINK2X-Pro here:
Buy the RetriTINK2X-Scart here: